Starting RX DMA on THRI interrupt is too early because TX may not have
finished yet.
This change is inspired by commit 90b8596ac460 ("serial: 8250: Prevent
starting up DMA Rx on THRI interrupt") and fixes DMA issues I had with
an AM62 SoC that is using the 8250 OMAP variant.
Signed-off-by: Ronald Wahl <ronald.wahl@raritan.com>
---
drivers/tty/serial/8250/8250_omap.c | 9 +++++----
1 file changed, 5 insertions(+), 4 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_omap.c b/drivers/tty/serial/8250/8250_omap.c
index c7ab2963040b..f2f59ec6b50b 100644
--- a/drivers/tty/serial/8250/8250_omap.c
+++ b/drivers/tty/serial/8250/8250_omap.c
@@ -1282,10 +1282,11 @@ static int omap_8250_dma_handle_irq(struct uart_port *port)
status = serial_port_in(port, UART_LSR);
- if (priv->habit & UART_HAS_EFR2)
- am654_8250_handle_rx_dma(up, iir, status);
- else
- status = omap_8250_handle_rx_dma(up, iir, status);
+ if ((iir & 0x3f) != UART_IIR_THRI)
+ if (priv->habit & UART_HAS_EFR2)
+ am654_8250_handle_rx_dma(up, iir, status);
+ else
+ status = omap_8250_handle_rx_dma(up, iir, status);
serial8250_modem_status(up);
if (status & UART_LSR_THRE && up->dma->tx_err) {
--
2.41.0