There are two control lines controlled by GPIO going into ov5640

- Reset
- Powerdown

The driver and yaml expect "reset-gpios" and "powerdown-gpios" there has
never been an "enable-gpios".

Fixes: 39e0ce6cd1bf ("arm64: dts: qcom: apq8016-sbc: Add CCI/Sensor nodes")
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
---
 arch/arm64/boot/dts/qcom/apq8016-sbc.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/apq8016-sbc.dts b/arch/arm64/boot/dts/qcom/apq8016-sbc.dts
index ada0777567623..ddb19709a9eee 100644
--- a/arch/arm64/boot/dts/qcom/apq8016-sbc.dts
+++ b/arch/arm64/boot/dts/qcom/apq8016-sbc.dts
@@ -273,7 +273,7 @@ camera_rear@3b {
 		compatible = "ovti,ov5640";
 		reg = <0x3b>;
 
-		enable-gpios = <&tlmm 34 GPIO_ACTIVE_HIGH>;
+		powerdown-gpios = <&tlmm 34 GPIO_ACTIVE_HIGH>;
 		reset-gpios = <&tlmm 35 GPIO_ACTIVE_LOW>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&camera_rear_default>;
-- 
2.41.0