Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers.  Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.

Cc: Douglas Anderson <dianders@chromium.org>
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
---
 arch/arm64/boot/dts/qcom/apq8016-sbc.dts | 2 --
 1 file changed, 2 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/apq8016-sbc.dts b/arch/arm64/boot/dts/qcom/apq8016-sbc.dts
index 27ceaa94c8bd..59860a2223b8 100644
--- a/arch/arm64/boot/dts/qcom/apq8016-sbc.dts
+++ b/arch/arm64/boot/dts/qcom/apq8016-sbc.dts
@@ -729,7 +729,6 @@ usb_id_default: usb-id-default-state {
 		function = "gpio";
 
 		drive-strength = <8>;
-		input-enable;
 		bias-pull-up;
 	};
 
@@ -770,7 +769,6 @@ msm_key_volp_n_default: msm-key-volp-n-default-state {
 		function = "gpio";
 
 		drive-strength = <8>;
-		input-enable;
 		bias-pull-up;
 	};
 };
-- 
2.34.1

On Fri, 7 Apr 2023 20:00:45 +0200, Krzysztof Kozlowski wrote:
> Pin configuration property "input-enable" was used with the intention to
> disable the output, but this is done by default by Linux drivers.  Since
> patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
> input-enable") the property is not accepted anymore.
> 
> 

Applied, thanks!

[1/1] arm64: dts: qcom: apq8016: remove superfluous "input-enable"
      commit: 8624e6063cb15cc7ceeee6d54fc1761ab3d0baf7

Best regards,
-- 
Bjorn Andersson <andersson@kernel.org>