Currently if a software reset is attempted on an idxd device
the workqueues will not be re-enabled, because it will see
incorrectly see that wq->state is already set to IDXD_WQ_ENABLED.
So set the workqueue state to disabled in idxd_wq_disable_cleanup(),
and use a bitmap to track which workqueues have been enabled so they
can be re-enabled during device re-initialization.

Changes from v1 to v2:
- Clear bit in case where idxd_wq_enable() fails during re-init.


Cc: Fenghua Yu <fenghua.yu@intel.com>
Cc: Dave Jiang <dave.jiang@intel.com>
Cc: Vinod Koul <vkoul@kernel.org>

Jerry Snitselaar (2):
  dmaengine: idxd: Set wq state to disabled in idxd_wq_disable_cleanup()
  dmaengine: idxd: track enabled workqueues in bitmap

 drivers/dma/idxd/device.c | 4 +++-
 drivers/dma/idxd/idxd.h   | 2 ++
 drivers/dma/idxd/init.c   | 6 ++++++
 drivers/dma/idxd/irq.c    | 5 +++--
 drivers/dma/idxd/sysfs.c  | 1 +
 5 files changed, 15 insertions(+), 3 deletions(-)

-- 
2.37.2

On 28-09-22, 08:48, Jerry Snitselaar wrote:
> Currently if a software reset is attempted on an idxd device
> the workqueues will not be re-enabled, because it will see
> incorrectly see that wq->state is already set to IDXD_WQ_ENABLED.
> So set the workqueue state to disabled in idxd_wq_disable_cleanup(),
> and use a bitmap to track which workqueues have been enabled so they
> can be re-enabled during device re-initialization.

Applied, thanks

-- 
~Vinod