From: Olga Kitaina <okitain@gmail.com>
commit e16eceea863b417fd328588b1be1a79de0bc937f upstream.
According to the Arasan NAND controller spec, the flash clock rate for SDR
must be <= 100 MHz, while for NV-DDR it must be the same as the rate of the
CLK line for the mode. The driver previously always set 100 MHz for NV-DDR,
which would result in incorrect behavior for NV-DDR modes 0-4.
The appropriate clock rate can be calculated from the NV-DDR timing
parameters as 1/tCK, or for rates measured in picoseconds,
10^12 / nand_nvddr_timings->tCK_min.
Fixes: 197b88fecc50 ("mtd: rawnand: arasan: Add new Arasan NAND controller")
CC: stable@vger.kernel.org # 5.8+
Signed-off-by: Olga Kitaina <okitain@gmail.com>
Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@xilinx.com>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/linux-mtd/20220628154824.12222-3-amit.kumar-mahapatra@xilinx.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/mtd/nand/raw/arasan-nand-controller.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)
--- a/drivers/mtd/nand/raw/arasan-nand-controller.c
+++ b/drivers/mtd/nand/raw/arasan-nand-controller.c
@@ -1043,7 +1043,13 @@ static int anfc_setup_interface(struct n
DQS_BUFF_SEL_OUT(dqs_mode);
}
- anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK;
+ if (nand_interface_is_sdr(conf)) {
+ anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK;
+ } else {
+ /* ONFI timings are defined in picoseconds */
+ anand->clk = div_u64((u64)NSEC_PER_SEC * 1000,
+ conf->timings.nvddr.tCK_min);
+ }
/*
* Due to a hardware bug in the ZynqMP SoC, SDR timing modes 0-1 work