On Mon, Nov 06, 2023 at 08:46:11PM -0800, Can Guo wrote:
> From: Can Guo <quic_cang@quicinc.com>
>
> Set the initial PHY gear to max HS gear for hosts with HW ver 5 and newer.
>
How about,
"For UFSHC >= 5.0, set the initial PHY gear based on the gear value returned by
ufs_qcom_get_hs_gear(). For the rest, use the existing default value of G2."
> This patch is not changing any functionalities or logic but only a
> preparation patch for the next patch in this series.
>
You are also moving the default phy_gear code to ufs_qcom_set_host_params(). So
it should be mentioned in the commit message.
> Signed-off-by: Can Guo <quic_cang@quicinc.com>
> ---
> drivers/ufs/host/ufs-qcom.c | 14 ++++++++------
> 1 file changed, 8 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/ufs/host/ufs-qcom.c b/drivers/ufs/host/ufs-qcom.c
> index 55ee31d..94d34b5 100644
> --- a/drivers/ufs/host/ufs-qcom.c
> +++ b/drivers/ufs/host/ufs-qcom.c
> @@ -1069,6 +1069,14 @@ static void ufs_qcom_set_host_params(struct ufs_hba *hba)
>
> /* This driver only supports symmetic gear setting i.e., hs_tx_gear == hs_rx_gear */
> host_params->hs_tx_gear = host_params->hs_rx_gear = ufs_qcom_get_hs_gear(hba);
> + host->phy_gear = host_params->hs_tx_gear;
> +
> + /*
> + * Power up the PHY using the minimum supported gear (UFS_HS_G2).
> + * Switching to max gear will be performed during reinit if supported.
> + */
This comment should be moved inside the "if" condition here as done in the next
patch.
- Mani
> + if (host->hw_ver.major < 0x5)
> + host->phy_gear = UFS_HS_G2;
> }
>
> static void ufs_qcom_set_caps(struct ufs_hba *hba)
> @@ -1313,12 +1321,6 @@ static int ufs_qcom_init(struct ufs_hba *hba)
> dev_warn(dev, "%s: failed to configure the testbus %d\n",
> __func__, err);
>
> - /*
> - * Power up the PHY using the minimum supported gear (UFS_HS_G2).
> - * Switching to max gear will be performed during reinit if supported.
> - */
> - host->phy_gear = UFS_HS_G2;
> -
> return 0;
>
> out_variant_clear:
> --
> 2.7.4
>
--
மணிவண்ணன் சதாசிவம்