docs/specs/index.rst | 1 + docs/specs/sev-guest-firmware.rst | 125 ++++++++++++++++++++++++++++++ 2 files changed, 126 insertions(+) create mode 100644 docs/specs/sev-guest-firmware.rst
Add docs/specs/sev-guest-firmware.rst which describes the GUIDed table
in the end of OVMF's image which is parsed by QEMU, and currently used
to describe some values for SEV and SEV-ES guests.
Signed-off-by: Dov Murik <dovmurik@linux.ibm.com>
---
docs/specs/index.rst | 1 +
docs/specs/sev-guest-firmware.rst | 125 ++++++++++++++++++++++++++++++
2 files changed, 126 insertions(+)
create mode 100644 docs/specs/sev-guest-firmware.rst
diff --git a/docs/specs/index.rst b/docs/specs/index.rst
index ecc43896bb..2a35700fb3 100644
--- a/docs/specs/index.rst
+++ b/docs/specs/index.rst
@@ -18,3 +18,4 @@ guest hardware that is specific to QEMU.
acpi_mem_hotplug
acpi_pci_hotplug
acpi_nvdimm
+ sev-guest-firmware
diff --git a/docs/specs/sev-guest-firmware.rst b/docs/specs/sev-guest-firmware.rst
new file mode 100644
index 0000000000..3f7f082df5
--- /dev/null
+++ b/docs/specs/sev-guest-firmware.rst
@@ -0,0 +1,125 @@
+====================================================
+QEMU/Guest Firmware Interface for AMD SEV and SEV-ES
+====================================================
+
+Overview
+========
+
+The guest firmware image (OVMF) may contain some configuration entries
+which are used by QEMU before the guest launches. These are listed in a
+GUIDed table at a known location in the firmware image. QEMU parses
+this table when it loads the firmware image into memory, and then QEMU
+reads individual entries when their values are needed.
+
+Though nothing in the table structure is SEV-specific, currently all the
+entries in the table are related to SEV and SEV-ES features.
+
+
+Table parsing in QEMU
+---------------------
+
+The table is parsed from the footer: first the presence of the table
+footer GUID (96b582de-1fb2-45f7-baea-a366c55a082d) at 0xffffffd0 is
+verified. If that is found, two bytes at 0xffffffce are the entire
+table length.
+
+Then the table is scanned backwards looking for the specific entry GUID.
+
+QEMU files related to parsing and scanning the OVMF table:
+ - ``hw/i386/pc_sysfw_ovmf.c``
+
+The edk2 firmware code that constructs this structure is in the
+`OVMF Reset Vector file`_.
+
+
+Table memory layout
+-------------------
+
++------------+--------+-----------------------------------------+
+| GPA | Length | Description |
++============+========+=========================================+
+| 0xffffff80 | 4 | Zero padding |
++------------+--------+-----------------------------------------+
+| 0xffffff84 | 4 | SEV hashes table base address |
++------------+--------+-----------------------------------------+
+| 0xffffff88 | 4 | SEV hashes table size (=0x400) |
++------------+--------+-----------------------------------------+
+| 0xffffff8c | 2 | SEV hashes table entry length (=0x1a) |
++------------+--------+-----------------------------------------+
+| 0xffffff8e | 16 | SEV hashes table GUID: |
+| | | 7255371f-3a3b-4b04-927b-1da6efa8d454 |
++------------+--------+-----------------------------------------+
+| 0xffffff9e | 4 | SEV secret block base address |
++------------+--------+-----------------------------------------+
+| 0xffffffa2 | 4 | SEV secret block size (=0xc00) |
++------------+--------+-----------------------------------------+
+| 0xffffffa6 | 2 | SEV secret block entry length (=0x1a) |
++------------+--------+-----------------------------------------+
+| 0xffffffa8 | 16 | SEV secret block GUID: |
+| | | 4c2eb361-7d9b-4cc3-8081-127c90d3d294 |
++------------+--------+-----------------------------------------+
+| 0xffffffb8 | 4 | SEV-ES AP reset RIP |
++------------+--------+-----------------------------------------+
+| 0xffffffbc | 2 | SEV-ES reset block entry length (=0x16) |
++------------+--------+-----------------------------------------+
+| 0xffffffbe | 16 | SEV-ES reset block entry GUID: |
+| | | 00f771de-1a7e-4fcb-890e-68c77e2fb44e |
++------------+--------+-----------------------------------------+
+| 0xffffffce | 2 | Length of entire table including table |
+| | | footer GUID and length (=0x72) |
++------------+--------+-----------------------------------------+
+| 0xffffffd0 | 16 | OVMF GUIDed table footer GUID: |
+| | | 96b582de-1fb2-45f7-baea-a366c55a082d |
++------------+--------+-----------------------------------------+
+| 0xffffffe0 | 8 | Application processor entry point code |
++------------+--------+-----------------------------------------+
+| 0xffffffe8 | 8 | "\0\0\0\0VTF\0" |
++------------+--------+-----------------------------------------+
+| 0xfffffff0 | 16 | Reset vector code |
++------------+--------+-----------------------------------------+
+
+
+Table entries description
+=========================
+
+SEV-ES reset block
+------------------
+
+Entry GUID: 00f771de-1a7e-4fcb-890e-68c77e2fb44e
+
+For the initial boot of an AP under SEV-ES, the "reset" RIP must be
+programmed to the RAM area defined by this entry. The entry's format
+is:
+
+* IP value [0:15]
+* CS segment base [31:16]
+
+A hypervisor reads the CS segment base and IP value. The CS segment
+base value represents the high order 16-bits of the CS segment base, so
+the hypervisor must left shift the value of the CS segment base by 16
+bits to form the full CS segment base for the CS segment register. It
+would then program the EIP register with the IP value as read.
+
+
+SEV secret block
+----------------
+
+Entry GUID: 4c2eb361-7d9b-4cc3-8081-127c90d3d294
+
+This describes the guest RAM area where the hypervisor should inject the
+Guest Owner secret (using SEV_LAUNCH_SECRET).
+
+
+SEV hashes table
+----------------
+
+Entry GUID: 7255371f-3a3b-4b04-927b-1da6efa8d454
+
+This describes the guest RAM area where the hypervisor should install a
+table describing the hashes of certain firmware configuration device
+files that would otherwise be passed in unchecked. The current use is
+for the kernel, initrd and command line values, but others may be added.
+
+
+.. _OVMF Reset Vector file:
+ https://github.com/tianocore/edk2/blob/master/OvmfPkg/ResetVector/Ia16/ResetVectorVtf0.asm
--
2.25.1
On Mon, Jan 03, 2022 at 11:14:13AM +0200, Dov Murik wrote: > Add docs/specs/sev-guest-firmware.rst which describes the GUIDed table > in the end of OVMF's image which is parsed by QEMU, and currently used > to describe some values for SEV and SEV-ES guests. > > Signed-off-by: Dov Murik <dovmurik@linux.ibm.com> > --- > docs/specs/index.rst | 1 + > docs/specs/sev-guest-firmware.rst | 125 ++++++++++++++++++++++++++++++ > 2 files changed, 126 insertions(+) > create mode 100644 docs/specs/sev-guest-firmware.rst Reviewed-by: Daniel P. Berrangé <berrange@redhat.com> Regards, Daniel -- |: https://berrange.com -o- https://www.flickr.com/photos/dberrange :| |: https://libvirt.org -o- https://fstop138.berrange.com :| |: https://entangle-photo.org -o- https://www.instagram.com/dberrange :|
On 04/01/2022 20:07, Daniel P. Berrangé wrote: > On Mon, Jan 03, 2022 at 11:14:13AM +0200, Dov Murik wrote: >> Add docs/specs/sev-guest-firmware.rst which describes the GUIDed table >> in the end of OVMF's image which is parsed by QEMU, and currently used >> to describe some values for SEV and SEV-ES guests. >> >> Signed-off-by: Dov Murik <dovmurik@linux.ibm.com> >> --- >> docs/specs/index.rst | 1 + >> docs/specs/sev-guest-firmware.rst | 125 ++++++++++++++++++++++++++++++ >> 2 files changed, 126 insertions(+) >> create mode 100644 docs/specs/sev-guest-firmware.rst > > Reviewed-by: Daniel P. Berrangé <berrange@redhat.com> > Phil, Can you please add this to your queue? (I assume this is yours because this is documentation of OVMF-QEMU interface) The patch itself: https://lore.kernel.org/qemu-devel/20220103091413.2869-1-dovmurik@linux.ibm.com/ (I see I didn't CC you then. Sorry.) Thanks, Dov
On 15/2/22 07:21, Dov Murik wrote: > On 04/01/2022 20:07, Daniel P. Berrangé wrote: >> On Mon, Jan 03, 2022 at 11:14:13AM +0200, Dov Murik wrote: >>> Add docs/specs/sev-guest-firmware.rst which describes the GUIDed table >>> in the end of OVMF's image which is parsed by QEMU, and currently used >>> to describe some values for SEV and SEV-ES guests. >>> >>> Signed-off-by: Dov Murik <dovmurik@linux.ibm.com> >>> --- >>> docs/specs/index.rst | 1 + >>> docs/specs/sev-guest-firmware.rst | 125 ++++++++++++++++++++++++++++++ >>> 2 files changed, 126 insertions(+) >>> create mode 100644 docs/specs/sev-guest-firmware.rst >> >> Reviewed-by: Daniel P. Berrangé <berrange@redhat.com> >> > > Phil, > > Can you please add this to your queue? (I assume this is yours > because this is documentation of OVMF-QEMU interface) Catching up for 7.0 I see Gerd merged it as 0a2a40da4f. Thank you Gerd!
© 2016 - 2024 Red Hat, Inc.