This v2 patchset is based on master. Since I'm not sure how long this
series will take for review, we could probably apply Dan's previous patch
10 first, then when I repost I can provide a revert patch when needed.
v2:
- Make the flag transparent to postcopy [Avihai]
- Fix qapi/ indents to 70 cols, copy Markus, Eric too [Avihai]
- Adjusted postcopy test, see patch 2 for details (because patch 1 now
don't influence postcopy anymore, due to this the test runs slightly
faster than v1 but hopefully provides better coverage on postcopy)
A new flag "switchover-hold" is added to allow src qemu explicitly hold
switchover for precopy migration. Note that this flag will not affect
postcopy switchover because src qemu already has migrate-start-postcopy,
which is a finer grained knob just for that. In general this flag only
affects reaching migration completion phase, when set it'll block it from
happening while keep the migration iteration going.
This can be used in two cases so far in my mind:
(1) One can use this parameter to start pre-heating migration (but not
really migrating, so a migrate-cancel will cancel the preheat). When
the user wants to really migrate, just clear the flag. It'll in most
cases migrate immediately because most pages are already synced.
(2) Can also be used as a clean way to do qtest, in many of the precopy
tests we have requirement to run after 1 iteration without completing
the precopy migration. Before that we have either set bandwidth to
ridiculous low value, or tricks on detecting guest memory change over
some adhoc guest memory position. Now we can simply set this flag
then we know precopy won't complete and will just keep going.
The 1st use case may look a bit like COLO where we can actually keep both
QEMU _mostly_ in sync. I'm not sure whether it can be useful anywhere,
though.
Patch 1 will introduce the new flag.
Patch 2 will leverage the new flag to speed up migration-test. An initial
test is this can make migration-test finish within a little bit less than
1m.
Please have a look, thanks.
Peter Xu (2):
migration: switchover-hold parameter
qtest/migration: Use switchover-hold to speedup
qapi/migration.json | 25 +++++++++++++--
migration/migration.h | 16 ++++++++++
migration/migration-hmp-cmds.c | 3 ++
migration/migration.c | 56 ++++++++++++++++++++++++++++++++--
migration/options.c | 17 +++++++++++
tests/qtest/migration-test.c | 39 +++++++++++++++++------
6 files changed, 140 insertions(+), 16 deletions(-)
--
2.40.1